Old Garage Door Spring Adjustment

One end of the spring is connected to the garage door track or frame.

Old garage door spring adjustment.

There are two torsion springs at each side of the garage door. Then add or release tension until you get the proper close rate photo 2. Adjustment to torsion springs can be dangerous because they must be adjusted with the door down and the spring under tension. Troubleshooting garage door springs.

If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers. The torsion spring helps the garage door open and close easily. If the door was closing too quickly move the spring to the next higher hole on the bracket. Adjusting garage door extension.

Retest the door balance as you did in step 1. Garage door springs are used to offset the weight of the door. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. Remove the locking pin.

Torsion springs must be adjusted with the door in the down position. Without the springs the door is very difficult to lift. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. Be sure to have all your tools inside before closing the door unless you have an alternate access door to the garage.

The other is attached to a pulley connected to the cable. Adjusting garage door springs is a common repair. Adjusting the tension or balance spring on an up and over garage door when the door feels heavy. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.

Adjust the springs on both sides of the door the same way. Once the spring is free of tension remove from its track hanger. Garage door springs offset the weight of the door and allow it to open and close with ease. This video applies t.

When garage doors won t close all of the way or they close unevenly spring adjustment may be called for. If it was opening too quickly move it to the next lower hole.